-
Posted by swsjbernstein on Oct 11th, 2009 at 3:12pm
Wire that connects damper to motor
I opened my Broan to clean it and the wire that connects to the motor that goes around and lifts and closes the damper was hanging off. What is the right way to reinstall -- which angle which direction.
-
Posted by pddawson on Aug 24th, 2009 at 7:25pm
installation
I have a Broan 732 bathroom vent/light/heater and no installation guide (I've had the gadget for threeo years now) any help?
-
Posted by pddawson on Aug 24th, 2009 at 7:25pm
installation
I have a Broan 732 bathroom vent/light/heater and no installation guide (I've had the gadget for threeo years now) any help?
-
Posted by pddawson on Aug 24th, 2009 at 7:24pm
installation
I have a Broan 732 bathroom vent/light/heater and no installation guide (I've had the gadget for threeo years now) any help?
-
Posted by bc99greene on Jul 12th, 2009 at 8:08pm
Replacing Trunnion Nut 93840003 on Broan Trash Compactor 1051-J
Since nut was stripped unable to count the number of revolutions to remove it. So, how can I position the new nut properly?
-
Posted by gtzeng on Jun 7th, 2009 at 2:26pm
how to empty canister
I released the clasps but bottom does not come off. Am afraid to pull harder b/c will tear off wall. What am I not doing correctly?
-
Posted by vance on Jun 3rd, 2009 at 8:10pm
power switch
The power shut off switch fell apart. I have 2 wires and 3 tabs on the new one. What goes where?
-
Posted by chit9000 on Mar 20th, 2009 at 10:42pm
Fan
the fan does not work, but the light does, so i know there is power to the unit. The wiring looks to be hooked up properly. Any sugestions?
-
Posted by edmehnert on Jan 25th, 2009 at 9:00am
electronic manual
check engine light is on
-
Posted by shelly57snyder on Nov 7th, 2008 at 9:27pm
Light bulb problem
We have the Broan Allure III range hood, had it about 2 years. One of the bulbs went out so we replaced it, the next day it blew that bulb. Took it apart to see what was going on, put new bulb in checked it before putting it back together both bulbs were working. When we got it back together turned …
-
Posted by djakup01 on Oct 22nd, 2008 at 8:33am
Unit always goes into defrost cylce
The unit always goes into defrost cycle when it is turned on, then it shuts off after 3 minutes. Does anyone know how to prevent this. There is not any frost in the unit it is 60 degrees out.
-
Posted by jamesteng1248 on Oct 12th, 2008 at 2:26am
top panel vent
why air flow out from the top panel vent even if the baffle reinstalled and block the vent already? What is the problem?
-
Posted by jjkovalski on Sep 27th, 2008 at 12:23am
wiring
My hood has a white, black and green wire(green already attached to the grounding point. I bought a 3-wire cord to connect up the hood. It of course has a green ground wire but has two grey wires instead of a white and black. Does it matter which grey goes to the white and black? If so, how do yo…
-
Posted by genedz7046 on Sep 1st, 2008 at 8:34pm
electrical problem
circuit has power, light bulbs ok but fan and lights do not work when buttons on control panel are pushed. Fan speed indicator lights do work.
-
Posted by mrhinsc4sns on Jul 17th, 2008 at 3:19pm
Replacement Key
I recently purchased a house that has a Broan 1052-B trash compactor. It has no key so we cannot use it. How do we go about obtaining a replacement key?
-
Posted by gautam_sushil on Jul 16th, 2008 at 4:56am
request for the setup
i want the install this programme
-
Posted by lizkovach on Jul 13th, 2008 at 12:50pm
Service Manual
Original Centerifugal switch on motor does not match replacement part number. Motor works. Looks like I need to replace the motor and switch?
-
Posted by lpaulkjr on Jul 6th, 2008 at 4:29pm
7" round duct/damper
What is the part# and the cost of the 7' round duct/damper for the QS1 hood
-
Posted by lpaulkjr on Jul 6th, 2008 at 3:14pm
Duct work
attemping to install a 42inch QS1 range hood in and older home.Problem kitchen cabinets over the stove has a 10inch duct work hole already cut in,howevere the center line of the QS1 fan is off to the left by about 6 inch.Question: can I use heat/air flex ducting to vent a range hood.I can cut out th…
-
Posted by tgfarrell on Jun 6th, 2008 at 7:44pm
stuck ram
The ram on my Broan compactor goes down but doesn't come back up. The motor keeps running. If I push up on the ram I can make it catch and it goes back up.