• adjusting springs
  
  
  Unfortunately, if the unit has been opened. the springs may have been installed but the leavers which attatch to the springs to re close the door may have not been seated correctly, resulting in the dorr being pushed open rather that pulled closed. The only solution is to remove the metal / plastic cosmetic fascia and locate the springs. Reseat the spring leavers ( you'll know they're correct because the tension on the sping when myou try to attatch it to the body of the unit will be high) so the door tries to clos and using pliers and screw driver, attatch the loop end of the spring onto the hole in the metal strap on the body of the unit. It may seem complicated, but if you or someone else removes the fascia of the washer it will look self explanatory. If the problem began after a service by a technician, I suggest you contact the organisation in question and have them correct the problem under the terms of the labour warranty.
  
  
  Was this comment useful?


• Thanks
  
  
  I will take on board your advice and give it a go!
  
  Again, many thanks!
  
  
  Was this comment useful?


• adjusting springs
  
  
  You're very welcome.
  
  
  Was this comment useful?

Add Comment