Filter
Top Products
Operating instructions
33
What to do, when...
Certain problems are due to the lack of simple maintenance or
oversights, which can be solved with the help of the instructions given
here, without calling out an engineer.
...a flashing fault code appears
The dishwasher will not start or stops during operation. The
intervention of an alarm is indicated by a combination of flashing
indicator lights and intermittent audible signals (see following chart).
Open the dishwasher door and carry out the following suggested
corrective actions.
Fault code / Malfunction
- indicator light of the
programme in progress
is flashing
- 1 intermittent audible
signal
- 1 flash of the "end of
programme" indicator
light
The machine does not fill
with water
The water tap is blocked or
furred with limescale.
The water tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
Clean out the siphon.The siphon is blocked.
Check the water drain
hose connection.
Clean the water tap.
Turn the water tap on.
Clean the filter in the
threaded hose fitting.
The water inlet hose has not
been correctly laid or it is
bent or squashed.
Check the water inlet hose
connection.
The water drain hose has not
been correctly laid or it is
bent or squashed.
Possible cause Solutions
- indicator light of the
programme in progress
is flashing
- 2 intermittent audible
signals
- 2 flashes of the "end of
programme" indicator
light
The dishwasher will not
drain
Close the water tap and
contact your local Service
Force Centre.
Protection against flooding is
active.
- indicator light of the
programme in progress
is flashing
- 3 intermittent audible
signals
- 3 flashes of the "end of
programme" indicator
light
152965 29/0en 11-02-2004 10:13 Pagina 33