Filter
Top Products
13
To set a different level, proceed as follows:
1. Press the On/Off pushbutton.
2. Press the "small load" and "delay start" pushbuttons simultaneously for
about 5 seconds, in the display will appear L4 which corresponds to the
current level.
2. Press the "delay start" pushbutton as many times as necessary until the
required level appears in the display. The level increases by 1 each time
the pushbutton is pressed. 5 seconds after this pushbutton has last
been pressed the dishwasher memorises the level selected and returns to
the programme setting mode.
SO281
If your water hardness is level 0 it is already soft and therefore there is
no need to use salt. With the setting of the water softener at level 0 the
salt indicator light on the control panel will always remain off.
152985 56/1 en-es 30-11-1999 15:04 Pagina 13