Filter
Top Products
- 5 -
GENERAL
Carefully read the following important information regarding installation safety and maintenance.
Keep this information booklet accessible for further consultations. The appliance has been designed
as a suction version (external exhaust) or as a filter version (internal air recycle) rangehood.
SAFETY PRECAUTION
1. Take care when the rangehood is operating simultaneously with an open fireplace or burner that
depend on the air in the environment and are supplied by other than electrical energy, as the
rangehood removes the air from the environment which a burner or fireplace need for combustion.
The negative pressure in the environment must not exceed 4Pa (4x10-5 bar). Provide adequate
ventilation in the environment for a safe operation of the rangehood. Follow the local laws applicable
for external air evacuation.
General Warnings.
· The appliance is not intended for use by young children or infirm persons without supervision.
· Young children should be supervised to ensure that they do not play with the appliance.
· If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
· There shall be adequate ventilation of the room when the rangehood is used at the same time as
appliances burning gas or other fuels.
· Ensure that the range hood is cleaned frequently.
· There is a risk of fire if cleaning is not carried out in accordance with the instructions.
· Do not flambé under the range hood.
Warnings for Installation:
· The exhaust air must not be discharged into a flue which is used for exhausting fumes from
appliances burning gas or other fuels.
· The minimum distance between the support surfaces of the cooking pots on the cooker top and the
lowest part of the rangehood must be at least 65 cm. If the instructions for the hob specify a greater
distance, please consider this.
· The regulations concerning the discharge of exhaust air have to be fulfilled.
INSTALLATION INSTRUCTIONS
Electric Connection
The appliance has been manufactured as a class II, therefore no earth cable is necessary. The
connection to the mains is carried out as follows: BROWN = L line BLUE = N neutral If not provided,
connect a plug for the electrical load indicated on the description label. Where a plug is provided, the
rangehood must be installed in order that the plug is easily accessible. An omnipolar switch with a
minimum aperture of 3mm between contacts, in line with the electrical load and local standards, must
be placed between the appliance and the network in the case of direct connection to the electrical
network.
If a connection tube composed of two parts is used, the upper part must be placed outside the lower
part. Do not connect the rangehood exhaust to the same conductor used to circulate hot air or for
evacuating fumes from other appliances generated by other than an electrical source.
MOUNTING OF THE HOOD IN THE LOWER PART OF A HANGING CUPBOARD
This appliance has to be built in the lower part of a hanging cupboard or in another support. For the
fixing use 4 screws, which are appropriate to that kind of cupboard, drilling the holes corresponding
to fig.1 and 2.
CHANGING FROM DUCTED HOOD TO RECIRCULATING.
To transform the rangehood from the extraction version to the re circulating one ask your supplier for
an activated carbon filter. Active carbon filters are necessary to depurate the air, that will be released
in the room. Filters are not washable; they cannot be regenerated and have to be replaced at most
every 4 months. The saturation of the activated carbon depends on the more or less prolonged use
of the hood, on the type of cooking and on the regularity of cleaning of the grease filter. The filter has
to be fitted to the intake side of the motor, which is inside the hood. Place the filter to the centre turning