Filter
Top Products
dispenses take much less time. Throughput is easily doubled
in this manner.
This key is NOT FUNCTIONAL unless the 4th digit of the "FLG"
parameter is set to 1 (xxx1x). To do this, see the SOFTWARE
MAINTENANCE section, PARAMETER TABLE, "FLG".
The shorter mixing time may be a problem. So the number of
FAST REPEAT cycles is kept as low as possible. Up to 4
repeats may occur.
Press the FAST key to toggle the FAST flag ON of OFF. When
set to (FAST OFF) the FAST mode will not operate. When set
to (FAST ON) every normal calibrated dispense will be
followed by up to 4 FAST repeat dispenses.
This series of 4 dispenses is terminated as soon as the
sensor is covered, which indicates the blender has "caught
up". The next cycle will then be a weighed cycle, followed
by the required series of fast cycles to catch up again.
Press * to toggle between (FAST ON) and (FAST OFF).
Press EXIT, to exit.
When the FAST mode is in operation, the display ( FAST) will
flash intermittently.
SETTING: Press once and the current setting of component 1 is
(SET) displayed. Display will say (1 X xx.x). X is material
type, either R, (REGRIND); N, (NATURAL); or A, (ADDITIVE).
xx.x is the current setting.
Press SET to step forward through all the settings.
Press * key to backup in the list.
NEW settings may be entered directly.
REGRIND and ADDITIVE settings are expressed as percents, up
to 99.9 percent. NATURAL is any number you wish (usually
weight). It is used to establish RATIOS with all other
NATURAL entries. When only one material is designated as a
NATURAL, the value of it's setting has no meaning, except
that it must be set to some value to operate.
If you wish to restrict the entry of settings to the PROGRAM
mode only, (password required), you may do so by altering
the _SE parameter for each component that you wish to "lock
out". See MAINTENANCE SECTION, PARAMETERS, _SE parameter.
TAG: This key allows two pieces of information to be "tagged"
onto all data that is either printed or retrieved through
the computer port. The items are WORK ORDER number and
OPERATOR number.
This key is NOT FUNCTIONAL unless the 2nd digit of the "FLG"
parameter is set to 1 (x1xxx). To do this, see the SOFTWARE
MAINTENANCE section, PARAMETER TABLE, "FLG".
Page 33