Filter
Top Products
Installing your Cooker Hood
8
Fitting the Chimney Stack:
To fit the upper chimney section,first expand
the chimney slightly to allow it to be fitted
over the wall brackets. Then secure the upper
section using the two self tapping screws
provided.
The lower chimney section should be located
following instructions on page 6,ensuring
that the lugs in the base of the chimney are
seated into the two recesses on either side of
the canopy.
ATTENTION: Should the lower chimney
section subsequently be removed,the two
securing lugs in the top canopy must be
released.
Once the chimney stack has been installed,fit
the two venting grilles into the apertures
located on either side of the upper chimney
stack. The grilles are marked with two arrows
and should be fitted with one arrow pointing
upwards and the other towards the front.
When used in the recirculation mode,ensure
the grilles are properly secured to the
recirculation spigot.
Fig.10