Cres Cor 1000-CH-AL Microwave Oven User Manual


 
Ovens
FL-2340
Rev. 5 (7/08) Page 4 of 14
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
5925 Heisley Road • Mentor, OH 44060-1833
HOW TO INSTALL CABINETS:
Remove all packing material from the inside and all 1.
vinyl from the outside of oven.
Place the oven in a well ventilated area on level oor. 2.
Clearance requirements: 3” (76mm) at the back, 2”
(51mm) at the top, 1” (25mm) at both sides.
Install the pan slide racks on the sidewalls, if necessary.3.
Slide drip pan(s) onto the bottom of the compartment(s).4.
Remove (3) screws at the bottom front of the oven, 5.
under the door (See Figure).
Screw the drip tray bracket to the oven in those holes 6.
and place the drip tray onto the bracket.
All models are rated at 208/240 Volts.
INSTALLATION INSTRUCTIONS (continued)
NOTE: OVENS NEED TO BE INSTALLED BY A
QUALIFIED PERSON.
Check the voltage selector switch which is under an access
cover on the back of the oven near the power cord.
Flip the switch “UP” for 208 Volts
Flip the switch “DOWN” for 240 Volts
MAKE SURE THE SWITCH POSITION MATCHES
YOUR POWER SOURCE.
DRIP TRAY
DRIP TRAY
BRACKET
SCREWS