Filter
Top Products
INSTALLATION
& OPERATING
INSTRUCTIONS
FOR
Aqua-Pure® Ice Maker Ice Filters come complete with
all the necessary hardware. All you need is a tube cutter,
a wrench and a knife. Simply follow the easy step-by-step
instructions inside the box to connect the Aqua-Pure
Ice Maker Water Filter to your refrigerator’s incoming cold
water line.
You can also count on your Aqua-Pure filter to eliminate
the problem of ice maker clogging and corrosion, and extend
the life of your equipment. And each filter gives you up to six
months of great tasting water. After 6 months, just replace the
filter. So start enjoying tastier beverages today.
INSTALLATION INSTRUCTIONS
• Do not install on line pressure above 125psi (862kPa).
• Do not use wicking or pipe dope sealer for fitting
connections into head of filter. Teflon® tape is
recommended.
• Protect from freezing. Drain filter when room temperature
drops below 32°F (0°C)
• Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
after the system.
• Do not install in direct sunlight.
• Installation must comply with existing state or local
plumbing codes.
PROCEDURE FOR INSTALLING THE FILTER
Read all instructions carefully before installing your filter.
For use on 1/4” copper or plastic tubing.
1. Shut-off your refrigerator’s water source.
2. Locate an easily
accessible section
of tubing. Shut-off
valve must be on
inlet side of filter.
3. Cut and remove a 6”
(152.4 mm) section of
tubing making sure ends
are cut square.
4. Unscrew nuts from filter
fittings and slip ferrules
and nuts over tubing ends.
If your tubing is plastic,
install the supplied plastic
inserts into ends of tube.
AP717
WATER FILTER