Dacor DDWF24S Dishwasher User Manual


 
11
Wash Cycles
Heavy Wash
Use for heavily soiled dishes like pots, pans, casserole dishes, etc. Additional
smaller items may be added after the larger items if there is still space to
conserve water and energy.
Normal Wash
Use for normally soiled plates, glasses, bowls, serving dishes and lightly
soiled pans. This cycle is best for normally soiled mixed loads.
Quick Wash
Use for very lightly soiled loads that are washed immediately after use. This
cycle can also be used for very lightly soiled glass, coffee cups, china or
other delicate items.
Rinse and Hold
Use to rinse dishes that you plan to wash later that day or for rinsing the
dishes while waiting for the machine to be lled. The temperature setting
cannot be changed for this cycle.
Operating Your Dishwasher
Water Temperature Table
Wash Cycle
Wash Water Temperature
When Set to “Normal” Setting
Wash Water Temperature
When Set to “Economy” Setting
Heavy Wash 160°F (70°C) 130°F (55°C)
Normal Wash 150°F (65°C) 130°F (55°C)
Quick Wash 140°F (60°C) 85°F (30°C)*
* Higher if water supply temperature is above 85°F.
Adding a Dish After You Start
You can add a dish, if needed, after starting your
dishwasher. Dacor recommends that you only add
items during the rst ve minutes of operation to
make sure they get clean.
To add a dish:
Slowly open the door. The dishwasher will stop 1.
operating.
Wait a moment for the steam to clear.2.
Without touching any of the hot surfaces or 3.
racks, insert the item into one of the racks,
following the normal loading instructions.
Close the door.4.
Push on the door handle to make sure that the 5.
door is completely shut. Operation will resume.
Pausing Dishwasher Operation
To temporarily pause dishwasher operation:
Open the door. The dishwasher stops operating.
To resume the cycle:
Close the door.
Changing the Wash Cycle After You
Start
You can change the cycle and/or temperature
selection after you start your dishwasher.
Push the 1. START/STOP button for three seconds.
The dishwasher will stop operating.
Push the 2. PROGRAM button repeatedly to select
the new wash cycle (the indicator for the desired
wash cycle will light).
If you want to change the temperature setting, 3.
push the temperature button repeatedly to toggle
between the “normal” and “economy” setting.
The temperature setting indicator is lit when the
temperature is set to normal.
Push the 4. START/STOP button.
Saving on Water and Energy Costs
To save energy, wait to run the wash cycle until
the dishwasher is full.
Use the economy temperature setting.
If the dishes are only lightly soiled you can
run the Quick Wash cycle and reduce the
temperature to 85°F (30°C).