Filter
Top Products
PLANNING
GUIDE
Web: http://www.Dacor.com
Corporate Phone: 800-793-0093
Specifications are subject to change without notice.
See installation instructions for additional details.
5.15
Epicure
®
Ranges
ER36D, ER48D
1/2
GAS - ELECTRICAL ACCESS DIMENSIONS
Model A B C
D E*
ER36D
5 5/8”
(142.9mm)
18 3/8”
(466.7mm)
10 3/4”
(273.0mm)
13 11/16”
(347.7mm)
7/8”
(22.2mm)
ER48D
3 13/16”
(96.8mm)
18 11/16”
(474.7mm)
9 3/8”
(238.1mm)
13 3/4”
(349.3mm)
1 1/8”
(28.6mm)
* The diameter on models equipped for use in Canada is ¼”
(6.4mm) larger than those stated. Canadian units come from
the factory pre-wired with an appliance cord. When installing an
appliance cord on models that are not pre-wired, the hole size must
be increased to 1 1/8” (1 3/8” for model ER48D) by removing the
conduit bracket inside the range electrical access box.
48” (1219mm)
**
**
**
** Optional
1 1/16” (27mm) to cooking
surface (top of grates) from
top of trim
Finished Side
Panel
Width: ER36D - 35 7/8” (911mm)
ER48D - 47 7/8” (1216mm)
NOTES:
1. When installing a backguard, always install it
before sliding the range into place.
B
A
C
D
Gas Regulator Access,
Cover Removed
Range Electrical Access,
Cover Removed
E Electrical Connection
Hole in Bottom
Inlet
Back of Range
Revised
03/10/09
All tolerances: +/- 1/16” (+/- 1.6mm) unless otherwise stated
GAS SUPPLY PRESSURE REQUIREMENTS*
Gas Type Manifold Pressure
Minimum Gas
Supply Pressure
Natural Gas 5” Water Column 6” Water Column
Propane (LP) 10” Water Column 11” Water Column
* Maximum gas supply pressure 1/2 p.s.i. for all models
WARNING
Observe all governing codes and ordinances during ◊
planning and installation. Contact your local building
department for further information.
This appliance must be installed in accordance with the ◊
accompanying installation instructions.
ELECTRIC CIRCUIT REQUIREMENTS
Range Model Circuit Required
Total Connected Load
ER36D
240 Vac, 4-wire* 60 Hz,
30 Amp. (Min.) 40 Amp.
(Recommended)
6.5 kW (28 Amp.)
ER48D
240 Vac, 4-wire* 60 Hz,
50 Amp.
10.0 kW (42 Amp.)
* 4-wire, two 120 Vac hot (L1 and L2), one neutral, one ground