Filter
Top Products
Operating Your Dishwasher
19
Use and Care Manual
The Cycle Memory Feature
Your dishwasher remembers the settings for the last cycle it ran.
If you want your dishwasher to run the same cycle as it ran the
previous time:
1. Press the START/STOP button once.
The START/STOP button light will flash and the lights on the
buttons for the last cycle and options run will be lit.
2. Press the START/STOP button again to run the
previous cycle (or you may select a different cycle, then
press START/STOP if you don’t want to run the
previous cycle).
3. Close the door. After a short pause, the dishwasher will begin to operate.
If the delay feature was used during the previous cycle, your dishwasher will
start after the number of hours originally selected.
Draining Standing Water
To drain standing water from the bottom of your dishwasher:
1. Press NORMAL.
2. Press START/STOP.
3. Press CANCEL.
4. Close the door. After a short pause, you will hear the
water in the dishwasher begin to drain. Once the water is drained, the
dishwasher will stop.
IMPORTANT: Your dishwasher also drains the water in the bottom at the
start of each wash and rinse cycle.
The SECURE Feature
To secure the control panel:
1. Press and hold the SECURE button down for three
seconds. All control panel lights are deactivated and
none of the buttons operate.
2. To turn off the secure feature, press and hold the SECURE button down
for three seconds.
The control panel beeps when you turn this feature on and off.
SECURE
START
STOP
START
STOP
NORMAL
START
STOP
CANCEL