Daewoo KOR-631G0P Microwave Oven User Manual


 
TROUBLE SHOOTING GUIDE
( TROUBLE 4 )
The following visual conditions indicate a probable defective touch control circuit or membrane switch
assembly
1. Incomplete segments,
1) Segments missing.
2) Partical segments missing.
3) Digit flickering other than normal display slight flickering.
4) “ : 0 ” does not display when power is on.
2. A distinct change in the diplay are not on when they
numbers is the display.
3. One or more digits in the diplay are not on when they should be.
4. Display indicates a number different from one touched.
5. Specific numbers (for example 2 or 3) will not display when the panel is touched.
6. Display does not count down or up with time cooking or clock operation.
7. Oven is programmable and cooks normally but no display shows.
8. Display obviously jumps in time while counting down.
9. Display counts down noticeably too fast while cooking.
10. Display does not show the time of day when clear pad is touched.
11. Oven lamp and turntable motor do not stop although cooking is finished. Check if the RELAY 2 contacts close if they are
close, replace touch control circuit.
CONDITION
CHECK RESULT CAUSE REMEDY
Display does
not show
programming
at all, even if
keyboard is
touched.
Normal
Replace
control box
sub-assembly
Replace the
membrane
keyborad
Malfunction
of touch
control circuit
of control box
sub-assembly
Abnormal
Check each pad for
continuity of the
membrane keyboard
for the following
keyboard check
procedure
Malfunction of
the membrane
keyboard
NOTE
Before following the particular steps listed above in the trouble shooting guide for the membrane keyborad’s, failure,
please check for the continuity of each wire-harness between the membrane keyboard and P.C.B. assembly.