Filter
Top Products
2
You are now the proud owner of one of
the finest and most modern products that
today's technology can produce.
Please read all the instructions carefully
as they contain information on how to
operate and care for your dishwasher so
that you may gain the maximum benefit
from it.
Store this book in a safe place for future
reference.
Unpacking
Remove all packaging material, accessories
and documentation from the machine.
Damage
Do not use the machine if it has been
damaged in transit. Report the damage
to your dealer, who will take the necessary
corrective action.
Positioning the dishwasher
The machine should be positioned in close
proximity to a cold water tap and a drain
outlet.
Adjust the feet by turning them in or out
until the machine stands level and stable.
Preparation
Every dishwasher is tested and run in the
factory before being dispatched. Before
washing dishes for the first time, it is
advisable to first complete a pre-wash
cycle to flush any factory related residuals
from the system.
The machine should be connected to a 15
Amp, 230 Volt 50 Hz, earthed, 3 pin wall
socket.
For safety reasons, the wall socket and
the plug should be accessible after
installation.
If the power cord should ever need
replacing, use only a genuine cord available
from the nearest Defy Service Centre.
The machine must be earthed and the
manufacturer and seller do not accept
responsibility for any damage due to
incorrect electrical connection.
Connect the filler hose to a 3/4 gas
threaded cold water tap.
The water supply pressure must be
between 0.3 and 10 bars.
If the supply plumbing is new or has not
been used for some time, it is advisable
to run the water until it is clear and free
from dirt.
Secure the end of the drain hose to a
drain pipe. Take care not to kink or twist
the drain hose.
Dear
Customer
Before use
Electrical
connection
Water
connection
Drain
requirements
320 mm minimum
800 mm maximum
Floor level
diameter
40 mm inside
Drain hose
Drain pipe