Filter
Top Products
PROJECT
ITEM #
QUANTITY DATE
APPROVAL
The Delfield Company, 980 S. Isabella Rd., Mt. Pleasant, MI 48858, U.S.A. • (800) 733-8821 • Fax (800) 669-0619 • www.delfield.com
Delfield reserves the right to make changes in design or specifications without prior notice. ©2002 The Delfield Company. All rights reserved. Printed in U.S.A.
Short form specifications
The exterior sides and top edge shall be 20-gauge galvanized steel.
Exterior bottom to be 14-gauge galvanized steel.
Inner liner shall be water tight and constructed of 22-gauge
stainless steel with a 1.25” (3.2cm) I.P.S. drain. Opening(s) shall
have throat liners constructed of high impact plastic. Unit to be
insulated with foamed-in-place polyurethane insulation with a non-
conductive breaker strip.
Each opening shall have an insulated, stainless steel folding lid
with high impact plastic liner, molded rubber edge and black plastic
handles.
(1) stainless steel louver shall be provided for installation in the
cabinet to allow proper airflow to the condensing unit.
Each self-leveling mechanism shall be field adjustable by adding or
removing stainless steel extension springs in the elevator housing
inside the unit. The elevators shall be connected by removable
platform carriers constructed of 18-gauge stainless steel.
Refrigeration system shall use HFC-134a refrigerant. Refrigerant
flow shall be controlled by an expansion value. Cabinet shall
maintain 36°F to 40°F (2°C to 4°C) temperature with lids closed
for storage. Refrigeration system shall be controlled by a pressure
control, located near the condensing unit.
Electrical connections shall be 115 volt, 60 cycle, and single phase.
Unit shall have a 9’ (2.7m) long electrical cord and NEMA 5-15P
installed at the mechanical end.
THE FOLLOWING APPLIES TO MODELS MFSC-2821,
MFSC-31, MFSC-44 AND MFSC-57 ONLY:
(6) anodized aluminum divider trays will be supplied per opening.
NOTE: See chart on back for milk storage capacity.
Optional Accessories & Modifications
• Lid locking device
• Wire baskets (not available on MFSC-2020)
• Lexan
®
covers
• Special voltages (contact factory)
MFSC
Built-in self contained milk or beverage dispensers
Model MFSC-31