Filter
Top Products
Project __________________________________
Item ____________________________________
Quantity ________________________________
CSI Section 11400
Approved _______________________________
Date ____________________________________
980 S. Isabella Rd.
Mt. Pleasant, Michigan 48858
Phone: 800-733-8948 or 989-773-7981
Fax: 800-669-0619
www.delfield.com
Exterior top shall be one-piece, 22-gauge stainless steel with
front edge turned down to form nosing and rear edge turned
down.
Exterior bottom shall be one-piece, 14-gauge galvanized
metal. Exterior ends shall be 22-gauge stainless steel.
Base interior shall be one-piece thermoformed ABS plastic
material, with integral shelf supports. ABS interior is backed
by a limited lifetime warranty. Cabinet shall have (4) epoxy-
coated wire shelves installed. Base shall be fully insulated with
high-density foamed-in-place environmentally friendly, Kyoto
Protocol Compliant, Non ODP (Ozone Depletion Potential),
Non GWP (Global Warming Potential) polyurethane.
Doors shall have a 22-gauge stainless steel exterior, with a
thermoformed ABS plastic interior liner, and shall be fully
insulated with foamed-in-place polyurethane. Door handles
shall be black, recessed ABS.
REFRIGERATION SYSTEM
THE FOLLOWING APPLIES TO MODEL UC4048
(REFRIGERATOR) ONLY:
Refrigeration system shall use HFC-404A refrigerant.
Compressor shall be 1/5 h.p., with condenser coil and hot
gas condensate evaporator mounted on rear of cabinet.
Evaporator coil and temperature control shall be mounted on
the interior rear wall of the cabinet. Refrigerant flow shall be
controlled by a capillary tube. Cabinet shall maintain 36°F to
40°F (2°C to 4°C) interior cabinet temperature.
THE FOLLOWING APPLIES TO MODEL UC4148 (FREEZER)
ONLY:
Refrigeration system shall use HFC-404A refrigerant.
Compressor shall be 1/3 h.p., with condenser coil and hot
gas condensate evaporator mounted on the rear of cabinet.
Evaporator coil and temperature control shall be mounted on
the interior rear wall of the cabinet. Refrigerant flow shall be
controlled by a capillary tube. Cabinet shall maintain -5°F to
0°F (-21°C to -18°C) interior cabinet temperature.
Electrical connections shall be 115 volt, 60 Hertz, single
phase. Unit shall have a 7’ (2.1m) long electrical cord and
NEMA 5-15P plug. Cord and plug shall be located on rear of
cabinet, 16” (40.6cm) above floor, 12” from left side.
Equipment is shipped with loose 6” (15.2cm) high metal legs
with black enamel finish unless mounting is specified on
original sales order.
Specifications
Standard Features
Options &
Accessories
Features Delfield’s exclusive ABS interior.
ABS is extremely durable - it won’t dent,
chip or corrode and is backed by a
limited lifetime warranty
Stainless steel front, sides and top
Environmentally friendly R404A
refrigerant
Foamed in place environmentally
friendly, Kyoto Protocol Compliant,
Non ODP (Ozone Depletion Potential),
Non GWP (Global Warming Potential)
polyurethane cuts energy costs
Four epoxy coated wire shelves standard
installed per unit
Black recessed quick grip handle
Rugged 6” high heavy duty metal legs
Door hinging available on either right or
left, right side is standard
7’ cord and plug supplied
•
•
•
•
•
•
•
•
•
UC4048 Undercounter refrigerator
Two section
UC4148 Undercounter freezer
Two section
•
•
Models
UC4000 Series
Self-Contained Undercounter Refrigerator/Freezer
UC4000 Series Self-Contained Undercounter Refrigerator/Freezer
Stainless steel back
Plastic laminate on front
Additional shelf
3.5” (8.9cm) diameter casters
(recommended for under counter)
5” (12.7cm) diameter caster also
available
Door lock
220 volt, 50 Hertz electrical system
•
•
•
•
•
•
•
UC4048