Filter
Top Products
SPEAKER OUTPUTS RIGHT / LEFT
The MP7 provides professional SPEAKON-type high-perfor-
mance connectors, which offer mechanically and electric secu-
re connection that complies with any safety standards.
Additionally, SPEAKON-type connectors allow utilizing high-
performance loudspeaker cables with diameters of up to 4 x
2.5mm
2
.
Single plugs and jacks as well as high-performance speaker
cables are available from the DYNACORD accessory assort-
ment.
POWER
Mains switch for switching the MP7’s power ON or OFF. The
appliance is operational when the POWER ON-LED lights and
the power relays have switched the power amplifier output
signal to the speaker outputs.
Before switching the mixer’s power on, make sure to set
the master faders to their minimum position. This will save
yourself, your audience, and your equipment from unne-
cessary stress resulting from switching or feedback noi-
se.
When switching your audio system on with additional power
amplifiers or other electronic equipment, like for example
CD-Players, MD-Recorders, etc. connected, please proceed
in the following sequence:
1. switch the CD-Player’s power on
2. switch the MP7’s power on
3. switch the additionally connected gear (power
amps) on
Please proceed in the opposite sequence when switching the
audio system off.
PHONO GROUND
Facility for connecting the chassis ground of a turntable. Make
sure to connect the chassis ground to the PHONO GROUND
screw. Otherwise you might be facing hum and interference
noise.
REAR PANEL
39