Filter
Top Products
In the following we will explain how to set up a standard PA-system with monitoring facility using the MP7.
The equipment list includes:
1 MP7
2 Hi-range speaker system cabinets, e.g. CP 12-2
2 Bass speaker system cabinets e.g. CP 12-1
2 Loudspeaker pole-mount stands or 2 intermediate poles
2 Speakon cables, 8m
2 Speakon cables, 2m
1 AM12 active monitor system
1 LF-cable with stereo phone plugs
Setting up
—
Look for the most suitable location to set up the loudspeaker systems. Whenever possible, place the bass
cabinets on the floor and the Hi-range cabinets directly on top. However, in doing so, make sure that the
hi-range cabinets’ lower edge is in the same height of the audience’s heads or above. You can either use
intermediate poles between the bass and Hi-range cabinets or, if this does not provide enough elevation for
the speaker systems or there are no bass cabinets included, use appropriate speaker pole-mount stands.
— Compact overall sound is achieved by placing the left and right loudspeakers as far apart from each other as
necessary but as close together as possible.
— Make sure that the main speakers are not behind you. Otherwise you will be facing feedback whenever your
system set-up includes microphones or turntables.
—
Use SPEAKON-type cables to establish connections between the loudspeaker systems and the MP7. Follow
the instructions as shown in figure1. Make sure not to inadvertently reverse connect the left and right channels.
The short SPEAKON-type cables are used to parallel connect Hi-range and Bass cabinets.
(Fig. 1)
STANDARD INSTALLATION
41