Filter
Top Products
EdgeStar Mini Kegerator 10
Removing the CO
2
line and mini keg
Once your mini keg is consumed, you need to shut off the CO
2
and
remove the keg.
Open the compartment located on the right-hand side of the mini
kegerator.
Shut off the regulator (turn the knob counter-clockwise).
Put a container under the dispenser and pour off any remaining
beer (this will also relieve some of the pressure in the mini keg).
Open the mini kegerator main door and disconnect the CO
2
line
and beer line.
Empty the remaining CO
2
from the mini keg with the CO
2
releaser
as shown:
Undo the tap from the mini keg by releasing the catch (on the top
of the tap) and pulling it up and out of the mini keg):
Rinse the tap out under running water. You should also clean it
with a mild detergent solution and rinse it thoroughly.
Clean the lines as directed in the under “Cleaning and
Maintenance” section.
Note that the optional accessories include a cleaning kit that uses CO
2
pressure to force the cleaning solution through the lines. To use this
system, fill the cleaning kit half full with your choice of cleaning solution
(water mixed with a bit of beer line cleaner, baking soda, or white
vinegar), connect it to the unit as if it were a non-pressurized mini keg,
and pour out all of the solution. Make sure to rinse the lines again!