Filter
Top Products
WARNING!
Deactivate the appliance before you do the checks.
Malfunction Possible cause Possible solution
The appliance does not fill
with water.
The water tap is blocked or
there is limescale on it.
Clean the water tap.
The water pressure is too low. Contact your local water au-
thority.
The water tap is closed. Open the water tap.
The filter in the water inlet
hose is blocked.
Clean the filter.
The connection of the water in-
let hose is not correct.
Make sure that the connection
is correct.
The water inlet hose is dam-
aged.
Make sure that the water inlet
hose has no damages.
The appliance does not drain
the water.
There is a blockage in the sink
spigot.
Clean the sink spigot.
The connection of the water
drain hose is not correct.
Make sure that the connection
is correct.
The water drain hose is dam-
aged.
Make sure that the water
drain hose has no damages.
The anti-flood device is on. Close the water tap and con-
tact the service centre.
The start of the washing pro-
gramme does not occur.
The appliance door is open. Close the appliance door.
The mains plug is not connec-
ted in the mains socket.
Connect the mains plug.
The fuse in the fuse box is dam-
aged.
Replace the fuse.
The delay start is set. • Cancel the delay start.
• When the countdown is
completed, the washing pro-
gramme starts automatical-
ly.
After the check, activate the appliance. The programme continues from the point of inter-
ruption.
If the malfunction occurs again, contact the service centre.
If the display shows other alarm codes, contact the service centre.
The necessary information for the service centre is on the rating plate.
Record this information:
– Model (MOD.) ........................................................
– Product number (PNC) ..........................................
– Serial number (S.N.) ..............................................
What to do if…
45