Fisher & Paykel 447443 Oven User Manual


 
27
Oven and Oven Runners
Clean the inside of the oven while still warm, using household detergents or an ammonia
based cleaner, e.g. Handy Andy. "Off the shelf" oven cleaners may be used providing the
instructions supplied by the manufacturer are followed carefully. Do not use oven cleaner on
self cleaning liners. The wire side runners may be removed to make cleaning easier.
To remove the runners:
Gently push the retaining wire underneath the stud down then lift the runners up and
towards the centre of the oven. The prongs at the top will slide out.
To replace the runners, hold the runner and push prongs fully into small slots at top of
oven cavity.
Lower runners and gently place retaining wire underneath the stud.
Warning
Do not lower runners until prongs are fully inserted.
Self Cleaning Liners
Self cleaning liners are fitted in some models of Built-In ovens. They help reduce manual
oven cleaning.
Self cleaning liners are fitted to the side walls and back of the oven. The liners are coated
with a special enamel which is porous and contains oxidising catalysts.
Any grease and dirt coming into contact with the liner is absorbed by the enamel and is
broken down with the help of the oxidising catalysts at normal cooking temperatures.
As cleaning is improved by using a high temperature, it may be necessary to run the oven at
Fan Grill, maximum temperature for one or two hours if needed.
The oven roof is self cleaning as the heat from the grill element will break down grease and
dirt which may be deposited.
Warning
Do not use any detergent, abrasives or oven cleaners on self cleaning liners.
Fat Filter
The fat filter should be cleaned after every use. For normal soiling, place in a dishwasher on
normal wash. If the fat filter is very dirty, place in a saucepan with either 2 tablespoons of
washing powder, or 1 tablespoon of dishwasher powder. Bring to the boil and leave to soak
for at least 30 minutes. Rinse the filter in clean water and dry.