Fisher & Paykel DD60DI7 Dishwasher User Manual


 
1H
Your model
Your remote control
Selecting a wash program
Loading and detergent
Signal indicator
A single flash
indicates a
successful
signal to the
dishwasher.
Multiple flashes
indicate that
the dishwasher
cannot read
the signal. The
remote control
may be out of
range.
Mounting your
remote
Your remote control
comes supplied with a
detachable mounting
bracket and self
adhesive strip. You can
choose to affix this
bracket on a nearby
surface, which should be
out of direct sunlight
and away from excessive
heat and steam. Do not
apply on wallpaper.
Slide off remote, then
press bracket firmly to
surface for 30 seconds.
Wait 1 hour before
refitting remote.
Press
remote & bracket
to clean, dry surface
for 10 seconds
10 seconds
30 seconds
Peel red liner off,
press adhesive to bracket
Doubles remote shown
Peel black
liner off
‘Battery low’ indicator
When this
flashes, the
battery needs to
be replaced. Use
a CR2032 battery,
ensuring the
+ symbol faces up.
Double models only
(operates lower drawer)
Control button(s)
See section ‘Operating instructions’
for information.
Important!
To prevent unauthorized use, keep the remote control out of reach of children.
Discard scraps
Scrape large food particles off
(e.g. bones, fruit stones) and
remove any foreign objects
(e.g. toothpicks, strings, paper).
Add detergent and check rinse
aid
Fill the detergent dispenser (a) with
powdered detergent and close the
dispenser door.
Important!
Do not place liquid detergent or tablets in
the detergent dispenser.
If the indicator on its plug (c) glows
bright red, refill the rinse aid
dispenser (b) with liquid rinse aid.
Make sure you then refit the rinse
aid plug back into its original
position.
If using a tablet, place it in the
cutlery basket (d) or at the bottom
of the drawer.
14
4
21
3
2
3
Load dishes carefully
To help with wash performance,
arrange dishes so they are
evenly spaced and not nesting.
Check spray arm(s)
Ensure there are no items
blocking the spray arm(s) from
rotating.
DD60DI7
DD24D(H)(T)I7
DD60S(T)I7
DD24S(H)(T)I7
DD90STI2
DD36STI2
Operating instructions
a
b
d
c
You can operate your dishwasher in two ways:
EITHER
by using the
button
on the drawer control panel
OR
by using the remote
control button
Note: each drawer in
double models has its own
controls and can run
independently of the
other drawer.
Start/resume wash
1
Press .
2
Close the drawer. The wash will start.
Pause wash
You can only pause the wash with the
remote. See opposite.
Cancel wash
1
Pause the wash with the remote.
2
Open the drawer, then press and
hold until you hear a
quick double beep.
Any water in the drawer will automatically
drain when you close it.
Set Delay start
To delay the start of a wash by 1 to 12
hours:
Press and hold . Count the beeps
as the dishwasher emits them (each
represents 1 more hour of delay) and
release the button when you have
reached the desired delay time.
The indicator of the selected wash
program will flash to show that Delay
start has been set.
The wash will start once the delay
time is over, provided the drawer is
closed.
Cancel Delay start
Press and hold
until you hear a quick
double beep and the indicator of the
selected wash program goes out.
Start/resume wash
1
Close the drawer.
2
Press . The wash will start.
Pause wash
Press
.
After pausing a wash, wait for 3 beeps
before opening the drawer. Forcing it open
in mid-cycle may cause damage or injury.
Cancel wash
Press and hold
until you hear a quick
double beep.
Any water in the drawer will automatically
drain.
Set Delay start
You can only set Delay start on the drawer
control panel. See opposite.
Cancel Delay start
Press and hold
until you hear a quick
double beep.
Keep this document handy for easy reference.
For detailed information on the features of your dishwasher, see your ‘User guide’.
Before using your dishwasher, make sure you read the full ‘User guide’, with special attention to the ‘Safety and warnings’ section.
For contact information or if you require service, assistance or replacement parts, see the end of this document or your ‘Service & warranty’ booklet.
NZ AU US CA
QUICK START GUIDE
DishDrawer
TM
dishwasher (Integrated)
ECO indicator
The indicator will
glow red when an
Eco program has
been selected.
If you require
enhanced
drying, we do
not recommend
selecting an Eco
program.
Wash
program
selector
Press to
scroll
through the
wash
programs.
STANDARD PROGRAMS - designed to clean and dry your dishes
ECO PROGRAMS - designed to clean your dishes energy-efficiently
HEAVY
Heavily soiled
pots, pans and
dishes.
HEAVY ECO
Heavily soiled
everyday
dishes.
FAST
Lightly soiled
dishes.
FAST ECO
Lightly soiled,
non-greasy
dishes.
RINSE
Prevents
odors
and soils
drying on
dishes.
DELICATE
Lightly soiled
and heat
sensitive
crockery.
DELICATE
ECO
Lightly soiled,
non-greasy
and heat
sensitive
crockery.
NORMAL
Dishes with
normal
soils for
optimum
performance.
NORMAL
ECO
Normal soiled
dishes for
optimum
water and
energy use.
Wash program indicators
These show which program is selected.
continued over