Filter
Top Products
INSTALLATION INSTRUCTION
PRODUCT DIMENSIONS
APEX MODEL RH900 CQ SS
NZ/AUS Code 87947
UK Code 88793
EU Code 88955
APEX MODEL RH900 CM SM
NZ/AUS Code 87948
UK Code 88794
EU Code 88956
All Dimensions in mm
488
528
780 min
1064 max
330
897
21
115
290
104385 issue H
ECN: 04 036
CANOPY OPERATION
Thank you for purchasing a quality stainless steel or iridium canopy rangehood. We have a
high standard of quality control and each rangehood is tested and approved before it leaves
the factory.
IMPORTANT: Please read prior to installation or operation
•
Always switch power off prior to installing, servicing or cleaning the appliance.
•
Never use the appliance without filters.
• Please read the notes on general cleaning, especially the filters.
• Exhaust air must not be discharged into a heating flue or wall cavity, unless the cavity is
designed for that purpose.
• Areas where the rangehood is installed that also have gas, oil or coal fired heaters, must be
well ventilated to prevent a partial vacuum in the room. This includes gas hobs. (A
partial vacuum in the room could result in too high a concentration of gas in the air).
• The appliance is supplied with an approved power cable which must not be changed. If the
supply cord of this equipment is damaged, it must only be replaced by the manufacturer
or its service agent or similarly qualified person in order to avoid hazard.
CONTROL PANEL
Particular care must be taken with grease filters which must be periodically cleaned (at
least every two months). Remove the grease filters and wash them either by hand or in the
dishwasher using mild detergent. In case of Charcoal Filter, it is a disposable item and
should be replaced when cleaning the rangehood. Use lukewarm water and mild detergent
to clean stainless steel components. In high humidity and coastal environments, cleaning
should be carried out frequently.
CAUTION: Never use abrasive or oil based liquid cleaners.
USE
Care and attention should always be taken when cooking with oils, alcohol, etc; which give
off flammable vapours.
Pre-used oil is especially dangerous in this respect.
Do not use uncovered electrical grill.
To avoid possible risks of fire always comply with the maintenance instruction above.
When making the electrical connection, check that the socket has an earth connection and
that the voltage values correspond to those indicated on the rating plate inside the
appliance. The appliance must be positioned so that the electrial plug is accessible.
Left Push Button = Light On/Off Switch
Second Push Button = Fan On High Speed
Third Push Button = Fan On Second Speed
Fourth Push Button = Fan On Low Speed
Fifth Push Button = Fan Off
INSTALLATION OF UNIT
The unit is designed for 2.4 to 2.65 metre high ceiling. The decorative chimney cover
is telescopic and is designed for 665 to 950mm adjustment.
Note: Ducting accessories are not supplied. Please refer to the optional ducting kits.
The air outlet from the motor requires 150mm round ducting which requires 160mm
diameter round hole in the ceiling. This hole will be covered by the decorative
chimney. Care should be taken to align canopy with decorative chimney allowing
sufficient clearance to accommodate the flexible ducting.
Before starting assembly, read the instructions carefully and remove the filters from
canopy to allow access to wall mounting holes. To remove the filters, pull the relative
catch and tilting it downwards until it disengages from the supports. Reverse these
instructions when refitting the filters.
Stainless steel/iridium is very easily damaged during installation if abraided or
knocked by tools.
PLEASE READ THE ENTIRE INSTRUCTION BEFORE INSTALLING THE CANOPY
MAINTENANCE