Filter
Top Products
- 6 -
MOUNTING THE DISPOSER
1. Loosen and remove the hinged clamp. (ILLUSTRATION #9).
2. The rubber splash guard should be attached to the waste disposal unit and not to the sink
flange. Using two hands, push the disposer upwards so that the inner groove on the splash
guard locks on to the sink flange. If necessary, use cooking oil to lubricate the inner rim on
the exposed side (top side) of the splash guard. Once engaged, the disposer will hang freely
by itself. (ILLUSTRATION #10).
3. Place the hinged clamp around the splash guard and lock in place. (ILLUSTRATION #11 &
#12).
4. The appliance must be installed so that the reset button is readily accessible.
ILLUSTRATION #9 ILLUSTRATION #10 ILLUSTRATION #11 ILLUSTRATION #12
PLUMBING CONNECTION
1. Check inside the disposer to make sure that no foreign
objects are inside the grinding hopper.
2. Rotate the disposer so that the discharge outlet faces
you. (ILLUSTRATION #13).