Open as PDF
IMPORTANT SAFETY NOTICE
The information provided herein is
designed to assist qualified repair
personnel only. Untrained persons
should not attempt to make repairs
due to the possibility of electrical
shock. Disconnect power cord
SERVICE DATA SHEET
This product is designed for “free standing installation only” and three inches
of clearance must be provided on all sides of the freezer for air circulation.
The freezer should be positioned on a solid ﬂoor, and the front of the
cabinet should be raised just enough to provide easy door closure when
open about half way.
REFRIGERANT CHARGE AND ELECTRICAL SPECIFICATIONS
Refer to serial plate.
4.0°F cut in, -10.0°F cut-out @ number 1 setting.
An automatic 30 minute defrosting period is initiated after every 12 hours of
compressor running time. During the defrosting period a thermostat will
switch the defrost heater off after the frost on the evaporator has melted.The
defrost thermostat closes at 10°F and opens at 50°F.
PERFORMANCE (Control at number 1 setting)
Room Ambient 70°F 90°F
Freezer Compartment Temperature 5 to 12°F 5 to 12°F
Percent Running Time 30-40% 45-55%
*Wattage Range (Last
⁄3 of cycle) 110-125 115-130
Suction Pressure (Cut-in, cut-out), PSIG 14-0 14-0
High Side Pressure (Last
⁄3 of cycle), PSIG 110-125 150-165
Specifications subject to change without notice.
*For complete performance data by model refer to service manual. PD645
If any green grounding
wires are removed dur-
ing servicing, they
must be returned to
their original position
and properly secured.
Low Side Process Tube