Filter
Top Products
3-2
ciency of the cooker and can cause erroneous temperature and water level sensing. NOTE: Do not use
deliming solution to clean these units. Use of deliming solution will damage all stainless steel parts.)
LOW WATER SENSING automatically de-energizes the heating element if the water in the cook-
pot drops too low. When the water level in the cookpot is below the low-water sensor, such as when
draining and cleaning the cookpot, the controller display will read LO.
NORMAL WATER LEVEL SENSING, on units configured with the Autofill feature, automatically
adds water during or after a cooking cycle if the water in the cookpot drops to a level lower than ap-
proximately 1¼ inch (32mm) below the overflow drain. With this automatic filling feature, the water
level does not have to be continuously monitored. The cookpot always has the correct amount of water.
3.2 Operating Instructions
Before turning the cooker on, ensure that:
• the unit is connected to the water supply.
• the water supply is turned on.
• the unit is plugged into an appropriate outlet.
• the electrical power supply is turned on.
CAUTION
If this is the first time the unit is being used after installation, refer to Section 3.4, Boiling
Out the Cookpot.
1. Turn the controller on by pressing the Power switch.
2. The unit will automatically enter the boil mode and the boil mode indicator will illuminate. If
you do not intend to immediately begin cooking, press the Simmer Mode switch. The sim-
mer mode indicator will illuminate. To re-enter the boil mode, press the Boil Mode switch.
3. Enter the desired cooking time using the numeric keypad. The time entered appears in the LED
display.
4. When ready to initiate a cooking cycle, press the Start Timer
switch. The basket lift will
automatically lower the basket or portion cups into the cookpot and the LED display will begin
to count down. At the end of the cooking cycle, an alarm will sound briefly to alert you and the
basket lift will automatically raise the basket or portion cups out of the water.
The display will automatically return to the previously set cooking time. If the same time is de-
sired for the next batch, simply press the Start Timer switch when ready, otherwise enter the
new cooking time before pressing the switch.
5. To initiate the automatic skimming (Autoskim) feature, press the Skim
switch.