Filter
Top Products
6-2
6.2 Accessing Equipment for Servicing
DANGER
Moving this equipment while it is filled with hot water may cause spilling or
splattering of the hot water. Always drain the cookpot before attempting to relocate
this equipment for servicing.
1. Disconnect the unit from the electrical power supply and from the water supply.
2. Remove any attached restraining devices.
3. Relocate the unit for service accessibility.
4. After servicing is complete, reconnect the unit to the water supply, reattach restraining devices,
and reconnect the unit to the electrical power supply.
6.3 Replacing Equipment Components
6.3.1 Replacing the Controller
See Section 5.4.
6.3.2 Replacing the Transformer, Basket Lift Relay, Contactor, or Solenoid Valve
1. Drain the cookpot and disconnect the cooker from the electrical power supply.
2. Remove the cover from the component box.
(It may be helpful to remove the drain
plumbing below the drain valve to better
access the interior of the component box.)
3. On the component to be replaced, make a
note of the wiring connection points.
4. Disconnect the wires and remove the failed
component (see illustration on next page).
Install the replacement component and
reconnect the wiring in accordance with the
notes made in Step 3 or with the wiring
diagram on the door of the unit.
5. Replace the component box cover, being sure to reconnect the ground wire. Replace any drain
plumbing components that were removed and reconnect the cooker to the electrical power
supply.