Filter
Top Products
GEAppliances.com
15
The reversible tine blocks (on some models) are
designed to allow greater flexibility in loading dishes.
The direction of the tine blocks can be changed to
match your preferred loading direction as shown in
Figure A or Figure B:
To adjust the tine block direction, remove the clips
securing the tine blocks to the racks by pulling up
on the tab, then gently flex the retaining wire from
the center to unseat the tine block from the lower
rack. The tine block may be turned in the opposite
direction to reverse loading direction. Secure the tine
block to the rack using the same process and be
sure to snap the clips back in place.
WARNING! The clips can be a choke
hazard for small children. Keep out of reach of
children.
To change the direction of the fold down tines, lower
the tines, then pull away from the bar clips that
secure the tines to the rack and remove. Reverse
the direction of the tines, orienting the handle on the
opposite side of the rack. Reattach the tines to the
bar clips by pushing the tines back until they click in
place. The indexer will also need to be switched to
the opposite side of the dishwasher. To remove the
indexer, simply slide it the in the direction labeled
“unlock.” Then, align the indexer with the rack on the
other side and slide in the direction that says “lock”
in order to reattach the indexer to the rack.
IMPORTANT:
It is important to ensure that items do
not protrude through the bottom of the rack or the
silverware basket where they will block the rotation
of the lower spray arm. Also, ensure that large
plates, pots, or tall items don’t hit the mid spray arm.
This could result in noise during operation and/or
poor wash performance.
Figure A Figure B
Clip
Indexer
To lock, slide right.
To unlock, slide left.
Bar Clip