Filter
Top Products
Problem Possible Causes What To Do
Dishes don’t dry
Low inlet water • Make sure inlet water
temperature temperature is correct
(see page 12).
• Select
HI TEMP RINSE
and/or
HEATED DRY.
Rinse agent dispenser • Check the rinse agent
is empty dispenser.
Control panel
Door latch may not be • Call for service.
responded to inputs
properly seated
but dishwasher never
filled with water
Dishwasher won’t run
Fuse is blown, or the • Replace fuse or reset
circuit breaker tripped circuit breaker. Remove
any other appliances from
the circuit.
• Try resetting the
START/RESET
pad.
Steam
This is normal • Steam comes through
the vent by the door latch
during drying and when
water is being pumped out.
Sanitized light does
The door was opened • Do not interrupt the cycle
not illuminate at the
and the cycle was
anytime during or after
end of the cycle
interrupted during or
main wash.
after the main wash
portion
The incoming water
• Raise the water heater
temperature was too low
temperature to 120°F.
Customer ServiceTroubleshooting TipsOperating InstructionsSafety Information
23