GE JCK 915 Oven User Manual


 
Using Auto Recipe
Conversion
When using convection bake, the Auto Recipe
Conversion feature will automatically convert
entered regular baking temperatures to
convection baking temperatures.
Once the feature is activated, the display
will show the actual converted (reduced)
temperature. For example, if you enter a regular
recipe temperature of 350°F and press the
START pad, the display will show CON
and the converted temperature of 325°F.
NOTE: This feature does not convert convection
bake cooking times, only temperatures.
Press the BAKE and BROIL HI/LO pads
at the same time for 3 seconds, until
the display shows SF.
Press the CONVECTION BAKE pad.
The display will show CON OFF. Press
the CONVECTION BAKE pad again.
The display will show CON ON.
Press the START pad.
To deactivate the feature, repeat steps
1–3 above but press the START pad when
CON OFF is in the display.
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips
Consumer Support
7
www.geappliances.ca
Tones at the End of a Timed Cycle
At the end of a timed cycle, 3 short beeps will
sound followed by one beep every 6 seconds until
the CLEAR/OFF pad is pressed. This continuous
6-second beep may be canceled.
To cancel the 6-second beep:
Press the BAKE and BROIL HI/LO
pads at the same time for 3 seconds,
until the display shows SF.
Press the KITCHEN TIMER ON/OFF
pad. The display shows CON BEEP
(continuous beep). Press the
KITCHEN TIMER ON/OFF pad
again. The display shows BEEP.
(This cancels the one beep every
6 seconds.)
Press the START pad.
Tone Volume
This feature allows you to adjust the tone
volumes to a more acceptable volume. There are
three possible volume levels.
Press the BAKE and BROIL HI/LO pads
at the same time for 3 seconds, until
the display shows SF.
Press the OVEN LIGHT ON/OFF pad.
The display will show 2 BEEP. This is
the middle volume level.
Press the OVEN LIGHT ON/OFF pad
again. The display will show 3 BEEP.
This is the loudest volume level.
Press the OVEN LIGHT ON/OFF pad
again. The display will show 1 BEEP.
This is the quietest volume level.
For each time the level is changed,
a tone will sound to provide an
indication of the volume level.
Choose the desired sound level
(1 BEEP, 2 BEEP or 3 BEEP).
Press the START pad to activate the
level shown.