GE JCKP70 Oven User Manual


 
1
If you have questions, call 1.800.561.3344 or visit our website at:
www.geappliances.ca
Built-In Wall Oven
27 (68.6 cm) models
Installation
Instructions
JCKS10, JCKP30, JCKP70, PCK916, PCK920
Materials Needed
Strain Relief Clamp
for 1/2 conduit
Junction
Box
Wire Nuts
91 cm (36) of String
Before You Begin
Read these instructions carefully and completely.
IMPORTANT—Save these
instructions for local inspector’s use.
IMPORTANT—Observe all
governing codes and ordinances.
Note to Installer—Be sure to leave these
instructions with the consumer.
Note to Consumer—Keep these
instructions for future reference.
Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
NOTE—This appliance must be properly
grounded.
ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
31-10666-3 11-07 JR
Tools Needed
1/8 (3 mm) Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
Parts Included
(Appearance will vary.)
Screws for Installation
(8-18 x .750 flat head
Phillips wood screws)
30 (76.2 cm) models
JCTP30, JCTP70, PCT916, PCT920
76.2 cm (30)
Metal Bottom Trim
Assembly
68.6 cm (27)
Metal Bottom Trim
WB07T10578 – Black
WB07T10579 – SS
Optional 68.6 cm (27)
Metal Bottom Trim Assembly
(on some models or can be
purchased separately)