Filter
Top Products
1
30” Built-In Wall Oven
Installation
Instructions
JTP20, JTP25, JTP28, JTP48, JTP50, JT912,
JT915, JT952, JT955, ZET938, ZET958
If you have questions, call 1.800.GE.CARES or visit our website at:
ge.com
Before You Begin
Read these instructions carefully and completely.
• IMPORTANT—Save these
instructions for local inspector’s use.
• IMPORTANT—Observe all
governing codes and ordinances.
• Note to Installer—Be sure to leave these
instructions with the consumer.
• Note to Consumer—Keep these
instructions for future reference.
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
• NOTE—This appliance must be properly
grounded.
• ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
Tools Needed
1/8” Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
Materials Needed
Strain Relief Clamp
for 1/2” conduit
Junction
Box
Wire Nuts
36” of String
31-10659 1-07 JR
Parts Included
Screws For
Installation
Metal
Bottom Trim
Plastic
Bottom Trim
Optional
Metal Bottom
Trim Assembly
(on some models)