GE JVM139K Microwave Oven User Manual


 
QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
OVEN WILL NOT COME
ON
CONTROL PANEL
LIGHTED, YET OVEN
WILL
NOT START
FOODS ARE EITHER
OVERCOOKED OR
UNDERCOOKED
“PRObE’7
APPEARS
ON DISPLAY
FLOOR OF THE
OVEN IS WARM,
EVEN WHEN THE
OVEN HAS NOT
BEEN USED
POSSIBLE CAUSE
A
fuse in your home may be blown or the circuit breaker tripped. Replace fuse
or reset circuit breaker.
Unplug
your microwave oven, then plug it back in.
Q
Make sure 3-prong plug on oven is fully inserted into wall receptacle.
Door not securely closed.
c
START pad must be touched after entering cooking selection.
Another selection entered already in oven and CLEAWOFF pad not touched
to cancel it.
Make sure you have entered cooking time after touching TIME COOK
I
& 11
pad.
CLEAWOFF pad was touched accidentally. Reset cooking program and touch
START pad.
Make sure you have entered a temperature after touching TEMP
COO~OLD
pad.
c
Make sure you have entered a code number after touching
AU~
ROAST pad.
Cooking times may vary because of starting food temperature, food density or
amount of foods in oven. Touch TIME COOK I &
11
pad and additional cooking
time for completion.
Incorrect power level entered. Check Cooking Guide for recommended
power
level.
Dish was not rotated, turned or stirred. Some dishes require specific
instructions. Check Cooking Guide or recipe for instructions.
Too many dishes in oven at same time. Cooking time must be increased when
cooking more than one food item. Check Cooking Guide time recommendations.
s
Probe not inserted properly into meat or dish when using Temp
CooMHold
or
Auto Roast function. Check Cooking Guide for specific instructions.
Probe has been forgotten or not seated properly in oven
wall
when using Temp
Coo~old
or Auto Roast function.
The
cooktop
lamp is located directly below the oven floor. When the lamp
is on, the heat it produces makes the oven floor get warm. This is normal.
All these things are normal with your microwave oven:
Steam
or
vapor escaping from Dimming oven light and change Some TV-Radio interference
around the door.
in blower sound may occur while
might be noticed while using your
Light reflection around door or
operating at power levels other
microwave oven. It’s similar to the
outer
case,
than high.
interference caused by other
small
Dull
thumping sound while oven
appliances and does not indicate a
is operating.
problem with your oven.
If you need more help...call, toll free: GE Answer Center
@
/ 800.626.2000/ consumer information service
38