GE ZEK737WW Oven User Manual


 
Installation
Built-In Ovens
16
• Outlet box
• Electrical cable—3-conductor or 4-conductor wire—as required
by local codes
• Flexible power cable connector
• Electrician’s pliers
Note:
Do not use an extension
cord with these appliances.
Monogram built-in single and double ovens require
a separate, properly grounded 3-wire 120/208 or 120/
240 volt, 60 Hz power supply, protected by a time
delay fuse or circuit breaker. Ovens are supplied with a
flexible power cable, which must be attached to a
junction box. The cable length is 48" for both single
and double conventional ovens. The cable length for
convection type ovens is 54".
Double ovens are rated 6.8 KW at 240 volt, and 5.1 KW
at 208 volt.
Single ovens are rated 3.4 KW at 240 volt, and 2.6 KW
at 208 volt.
Tools and
materials
required
The back of the ovens have chamfered corners which
provide a “chase” for the conduit when installing a
junction box above or below the oven(s).
The conduit is located on the back of the oven,
approximately 10" from the right side.
For double oven:
• Locate and install the junction box within reach of
the power cord.
Approximately 10" from the left side of opening
56" minimum above the cutout floor
or, through the left side of cabinet wall into
adjacent cabinet.
For single oven:
• Locate and install the junction box within reach of
the power cord.
Approximately 10" from left side of opening.
At least 5" below the cutout floor
Or 34" minimum above the cutout floor
or, through the left side of cabinet wall into
adjacent cabinet.
Double Oven:
Locate Junction Box
in one of the locations
Single Oven:
Locate Junction Box
in one of the locations
Electrical
locations