GE ZTD910SBSS Food Warmer User Manual


 
Monogram.
Specification Revised 11/99
ZTD910SBSS - GE Monogram 30" Warming Drawer
For answers to your Monogram,
®
GE Profile Performance Series,
GE Profile
or GE appliance questions, call
GE Answer Center
®
service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
26"
Including Handle
23-1/4"
30"
10-1/2"
9"
1"
Drawer
Open
27"
Warming Drawer Dimensions (in inches)
1" Min. Above Toekick or Adjust
to Oven Installation Height
28-1/2"
2" Min.
Allow 5/8"
Overlap on
All Sides
30"
10-1/2"
23-1/4"
23-1/2" Min.
Inside
Oven
Cutout
9-1/4"
2x2 or 2x4
Anti-Tip Block
Against Rear
Wall, 9" From
Floor to
Bottom of
Block
9"
Single Oven Installation (in inches)
28-1/2"
2" Min.
Allow 5/8"
Overlap on
All Sides
30"
10-1/2"
23-1/4"
23-1/2" Min.
Inside
1" Min. Above Toekick
Oven
Cutout
2x2 or 2x4
Anti-Tip Block
Against Rear
Wall, 9" From
Floor to
Bottom of
Block
9"
9-1/4"
Double Oven Installation (in inches)
Important Installation Note:
Must provide anti-tip brace at the back of the cabinet and at the top of
the cutout.
Optional Accessories:
JXPN1–Optional Pan Set Accessory for Warming Drawer.
Five commercial pans with lids (4” deep)
One large pan (14 quarts)
Two medium pans (6 quarts each)
Two small pans (3 quarts each)
ZXD30B–1/4” wood panel trim kit
Electrical
Outlet 16" Max.
From Left Side.
23-1/2" Min.
25"
1-1/2" Cabinet Top
36"
Countertop
Height
2" Min.*
28-1/2"
9-1/4"
Electrical Outlet 42" Max.
From Right Side.
Electrical Outlet
Flush With Side
of Cabinet 7" Max.
9"
Install
2x4 or 2x2
Anti-Tip Block
Against Rear
Cabinet Wall
9" From Floor
to Bottom
of Block
7"
Undercounter Installation (in inches)
Note: When installing warming drawer with a cooktop, allow a 2”
minimum from cooktop burner box bottom to top of cut-out.
Note: Additional clearance between cutouts may be required.
Check to be sure that oven supports above the Warming
Drawer location do not obstruct the required interior 23-1/2”
depth and 9-1/4” height.
9"
2x4 or 2x2
Runners or Solid Bottom
Install
2x4 or 2x2
Anti-Tip Block
Against Rear
Cabinet Wall
9" From Floor
to Bottom
of Block