HP (Hewlett-Packard) 7550 Printer User Manual


 
1 unpack your hp printer 2 plug in the power cord
3 load plain paper in the IN tray
1. Lift the OUT tray.
2. Pull out the paper length guide on the IN tray.
3. Slide the paper width guide as far to the left as it
will go.
4. Move the photo tray slider toward you until it stops.
This disengages the photo tray.
5. Place a stack of plain paper into the IN tray.
6. Adjust the paper width guide and paper length guide
to fit close to the edges of the paper without bending
the paper.
7. Lower the OUT tray.
1. OUT tray
4. Photo tray slider
2. Paper length guide5. IN tray
3. Paper width guide
Do not touch the
ink nozzles or the
copper contacts!
Setup Guide
Documentation
Software and
Printer Help on CD
HP #57
HP #58
Print cartridges
Power cord
5
8
5
7
56
3. Print cartridge cradle latch
1. Power button
2. Side door
4. Plastic tape
5.
6.
7. Calibration page
Q1605-90198
Printer
Copper contacts
1.
2.
3.
HP #56
Power module
4 install the print cartridges
1. Press the Power button to turn the printer on.
2. Insert your forefinger behind the notch on the
left side of the side door and pull out to open
the door.
3. Pop open each print cartridge cradle latch by
pulling out the bottom of the latch.
4. Remove the plastic tape from each print
cartridge.
5. Insert each print cartridge so the copper
contacts go in first.
Insert the HP #56 black print cartridge in the
right stall.
Insert the HP #57 tri-color print cartridge in the
middle stall.
Insert the HP #58 photo print cartridge in the left
stall.
6. Close each print cartridge cradle latch by
pulling out the bottom of the latch, pressing
down, then releasing the latch.
7. Close the side door and press the OK button.
A calibration page prints automatically. This
verifies that the print cartridges are installed
correctly.
hp photosmart 7550
setup
guide
!
Windows PC:
Be sure to insert the HP
Photosmart CD before you
connect the printer to your
computer with the USB cable.