Hobart LX18 Dishwasher User Manual


 
– 20 –
PROGRAMMABLE VARIABLES AND RECOMMENDED SETTINGS — MODELS LX40H & LX40C
The following functions of the dishwasher are programmable. The chart below shows the variables that
may be programmed for each function and the recommended setting for each.
RECOMMENDED
FUNCTION PROGRAMMABLE VARIABLES SETTING
Wash Setpoint H Models: 160°F - 170°F 165°F
C Models: 130°F - 150°F 130°F
Booster Setpoint 180°F - 199°F 190°F
Temperature Display Mode °F; °C °F
Sanitizer Duty Cycle (LX40C Only) OFF; 1 - 10 (In steps of 1) (10-100%) 40%
Detergent On Time OFF; 1 - 30 Seconds (In steps of 1) 7 Seconds
Rinse Agent Duty Cycle OFF; 1 - 10 (In steps of 1) (10-100%) 70%
Idle Shutdown Time 1 - 6 Hours (In steps of 1) 4 Hours
Cycle Selection (Lock/Unlock) Lock; Unlock Unlock
Default Cycle Light; Normal; Heavy Light
Delime Counter Preset *OFF; 500 - 3000 Cycles (In steps of 25) ***1500 Cycles
Detergent Prime Time **25 - 75 Seconds (In steps of 1) 35 Seconds
Rinse Agent Prime Time **25 - 75 Seconds (In steps of 1) 35 Seconds
Sanitizer Prime Time **25 - 75 Seconds (In steps of 1) 35 Seconds
Heavy Wash Time 100 - 200 Seconds (In steps of 1) 156 Seconds
Heavy Rinse Time Normal = 10 Sec.; Exten. = 20 Sec. Normal
* Disabled if OFF is programmed. Factory Setting is 1500 Cycles.
** Not available if pump is turned OFF.
*** Determined by water condition.
PREPARATION — ALL MODELS
Make sure the coarse (Fig. 5) and fine (Fig. 6) strainers are in place and free of debris. Check both
wash arms (all models) and rinse arms (models LX30, LX30H, LX30C, LX40H & LX40C only) to make
sure they spin freely and are not clogged.
Fig. 5 Fig. 6
Model LX30
Model LX30
PL-40091-1
Coarse Strainer
PL-40092-1
Fine Strainer