Filter
Top Products
UW50 WAREWASHING
F-40057 (10/03)
1
Place strainer pan and scrap
basket into position in the
dishwasher tank.
2
Close the access door
(automatically closes drains).
3
Tu rn selector switch to FILL
and press start.
4
Open door to reset
and load utensils on
rack as necessary,
slide rack into
machine and close
the door.
5
Change selector to
desired wash cycle
length (2, 4, or 6
minutes).
6
Press START.
To Stop:
1
Open machine door.
2
Tu rn selector to OFF position.
1
Tu rn selector to OFF position.
2
Open machine door.
3
Lift drain lever inside door
opening.
4
Remove and clean strainer pan
and strainer basket.
5
Spray down machine interior.
6
Visually inspect top and bottom
wash and rinse arms, if
obstructed remove arms and
spray free with water.
7
Remove overflow tube and
wash thoroughly.
8
Inspect tank interior, remove
any soil from heater, probes,
and floats
9
Wipe down exterior with a wet
wash rag.
DO NOT SPRAY THE
EXTERIOR WITH A HOSE
10
Reassemble the machine:
a. Install scrap screen and
basket
b. Install wash and rinse
arms if removed
Leave door open at end of day
to allow interior to air out.
To Operate:
To Clean:
1
After placing wash and rinse arms back in the machine,
verify they all spin freely prior to operating the unit.
2
Delime the machine on a regular basis. This assures proper
function of the machine.
Note: Refer to “Troubleshooting”
section of your UW50 Instruction
Manual or call your local Hobart
Sales/Service office if you
experience any difficulties.
Operational Tips:
Hobart Corporation, 701 S. Ridge Avenue, Troy, OH 45374-0001
Phone: (937) 332-3000 www.hobartcorp.com
3
6
7
10
3
4
1