Hotpoint FZA50 Freezer User Manual


 
FREEZER - MODELS FZM80, FZA80 & FZA50
INSTRUCTIONS FOR INSTALLATION & USE
GETTING STARTED:
To ensure that your freezer runs reliably and efficiently follow these steps.
Choose a location for your
freezer,away from any
heat sources and allow
adequate ventilation -
100mm (4 inches)
gap above.
Level the freezer by
adjusting the front feet.
This will stop rocking or
vibration and keep the
door aligned.
Plug in and switch on.
Allow the freezer to cool
before placing food
inside.
The high temperature
light will stay on until the
freezer has cooled down.
All food in the freezer
should be covered.
Move the freezer into
position,using the sides
of the cabinet. Take care
to avoid damaging the
refrigerant circuit pipe
work on the rear.
Before plugging in and
switching on,leave the
freezer in its final
location for at least 15
minutes to allow it to
settle.
If you are freezing fresh
food, turn on fast freeze by
pressing the switch 24
hours before placing the
food inside.
Place the fresh food
inside.
Read the rest of these instructions to get the best from your appliance
and remember to fill in your guarantee registration.
Keep this Book in a safe place for quick reference.
STEP 1
STEP 2
STEP 3
STEP 5
STEP 6
STEP 7
SAFETY &
INSTALLATION
CONTROLS USEFUL ADVICE
CLEANING &
MAINTENANCE
TROUBLESHOOTING
SERVICE &
GUARANTEE
Your freezer is now
working.
If after 24 hours your
freezer is not operating as
you want,refer to the
TROUBLESHOOTING
section.
STEP 8
Remember to turn fast freeze off
after 24 hours,however if you
forget to do so it will automatically
cancel after 48 hours.
After the front feet have
been adjusted and the
freezer is level fit the left
and right hand bottom
hinge covers supplied.
Align with the cover plate
slots and push into
position.
STEP 4
NB.The spanner is for illustration
only and is not supplied with the
freezer.