Filter
Top Products
1
Before Using Your Freezer
Remove the exterior and interior packing.
Check to be sure you have all of the
following parts:
1 Storage Basket
1 Instruction Manual
Before connecting the freezer to the power
source, let it stand upright for approximately
2 hours. This will reduce the possibility of a
malfunction in the cooling system from
handling during transportation.
Clean the interior surface with lukewarm
water using a soft cloth.
Installing Your Freezer
This appliance is designed to be free
standing only, and should not be recessed or
built-in.
Place your freezer on a floor that is strong
enough to support the freezer when it is fully
loaded.
Allow 15 cm of space between the back and
sides of the freezer, which allows the proper
air circulation.
Locate the freezer away from direct sunlight
and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase
electrical consumption. Extreme cold
ambient temperatures may also cause the
freezer not to perform properly.
Avoid locating the freezer in moist areas.
Plug the freezer into an exclusive, properly
installed-grounded wall outlet. Do not under
any circumstances cut or remove the third
(ground) prong from the power cord. Any
questions concerning power and/or
grounding should be directed toward a
certified electrician or an authorized service
center.
INSTALLATION INSTRUCTIONS
1
2
3
4
5
6
1.door seal
2.hanging basket
3.hinge
4.cabinet assembly foamed
5.outer tube
6.control panel
TABLE OF CONTENTS
3
6
7
INSTALLATION INSTRUCTIONS
OPERATING YOUR FREEZER
CARE AND MAINTENANCE
5
PROBLEMS WITH YOUR FREEZER
TROUBLESHOOTING GUIDE
2
2
Activate the super freeze function for 6 hours
before loading your food
Electrical Connection
For your safety please read the following
information
9
ASSISTANCE
RCAA 100 P
RCNAA 250 P
RCNAA 300 P