Filter
Top Products
RVM1335WC—Hotpoint 1.3 Cu. Ft. Counter Saver Plus
™
Microwave Oven
Specification Revised 6/00
R
Listed by
Underwriters
Laboratories
Dimensions (in inches)
21-3/4"
Door open
16-1/2"
66" MIN.
Mounting
height
from
floor
30"
MIN.
width
required
12"
MAX.
Exhaust outlet
connects to
3-1/4" X 10" duct
14"
15-7/8"
Important Information: When installing the Counter Saver Plus
™
microwave oven over a range, allow minimum of 2" from bottom of
Counter Saver Plus
™
microwave oven to top of range backguard to allow
for removal of light covers.
Installation Information: This information is not intended to be used for
installing unit described. Before installing, consult installation instructions
packed with product/kit for current dimensional data.
When replacing a 36" or 42"
range hood, this kit fills in the
additional width to provide a
custom, built-in appearance. For
installation between cabinets only;
not for end-of-cabinet installation.
Each kit contains two, 3"-wide filler
panels. Two kits are needed for a
42" opening.
JX81A–Recirculating
Charcoal Filter Kit
To be used when the
Counter Saver Plus
™
microwave oven cannot
be vented to the outside.
Optional Accessories (Available at additional cost)
12” Filler Panel Kits
JX41–Black Filler Panel Kit
JX40WH– White Filler Panel Kit
Ventilation Options: The Counter Saver Plus™ microwave oven is designed for adaptation
for the following three types o ventilation:
Outside Exhaust (Vertical–as shown above)
Outside Exhaust (Horizontal)
Recirculating Exhaust (Non-vented ductless–see Filter Kit Drawing)
Note: Before Installing, comsult installation instructions for curent dimensional data on
these therr types of ventilation