Filter
Top Products
1630460040
9/16/97
Rev A
IMI CORNELIUS INC.
One Cornelius Place
Anoka. MN 55303-6234
Telephone (800) 238–3600
Facsimile (612) 422–3246
INSTALLATION INSTRUCTIONS
“K” STYLE LID KIT, P/N 630000085
These “K” style kits apply to the following ice makers and are for use with DF/ED 200/250 dispensers:
Ice Maker Size
Hoshizaki KM250/450/500/630/650 22I
Table 1. Loose-Shipped Parts
Item
No. Part No. Name Qty.
1 630000310 Lid Assembly, “K” Style 1
2 15303 Bracket 1
3 50904 RTV, Clear, 732, 3 oz. Tube 1
4 630000311 Cover, RH Assembly 1
5 70217 #8 Sheet Metal Screw 6
6 90221 Label, Disconnect Before Cleaning 1
7 70188 Thumb Screw #8-32 1/2I 1
8 630460040 Installation Instruction 1
9 22127 Bracket, LS Mounting 1
1. Set Ice maker lid on the top of the dispenser and position it flush with the back and sides of the dispenser.
2. Using the slotted holes in the lid as a template, drill four (4) .140I diameter holes at the bottom of the slots
(see detail A). Use extreme care not to drill into the hopper. Fasten the lid to the dispenser with four (4) #8
sheet metal screws, two on each side.
3. Seal the ice maker to the top of the dispenser as follows:
A. Apply beads of RTV around the opening in the lid and inside the perimeter of the ice maker outline so
that the ice maker will set on the RTV.
B. Set the ice maker onto the lid and position it as required.
C. Wipe away any excess RTV.
4. Remove the two rear screws (only) installed in step 2. Use those screws to install the mounting brackets
(item 2 and/or item 9). Drill 9/64I diameter holes into the ice maker cabinet using the bracket as a tem-
plate. Use extreme caution not to drill into any ice maker components (condenser, tubing, etc.). Secure the
brackets using the screws provided.
5. Follow the ice maker manufacturers instruction to complete the installation of the ice maker including the
bin thermostat if so equipped or required.