Filter
Top Products
3 185211000
GENERAL INFORMATION
IMPORTANT: To the user of this manual – This manual is a guide for installing, operating, and
maintaining this equipment. Refer to Table of Contents for page location of detailed information
pertaining to questions that arise during installation, operation, service and maintenance, or
troubleshooting this equipment.
GENERAL DESCRIPTION
This section gives the description, installation requirements, theory of operation, design data, and flow diagram
for the Universal C-750 Four and Five-Flavor Pre-Mix Dispensers (hereafter referred to as Units).
This Unit must be installed and serviced by a qualified Service Person. This Unit contains no User serviceable
parts.
UNIT DESCRIPTION
The Universal C-750 Units are equipped with four eight-inch diameter wheels and a handle (see Figure 1)
enabling the Units to be mobile (moved from one location to another). A Water Tank Seal Kit (P/N 308979000) is
available for these Units which closes off the top of the water tank to eliminate or reduce water loss caused by
splashing during mobile movement of the Unit.
Installation of LOOSE-SHIPPED PARTS, connection to a grounded electrical outlet with proper electrical
requirements, filling water tank with water, and connection to product tanks with regulated CO
2
gas pressure is
all that is required to prepare the Unit for operation.
CAUTION: Before shipping, relocating, or storing the Unit, all product coils must be
sanitized and all sanitizing solution must be purged from the coils. Ice bank must be
melted and all water drained from the water tank. A freezing ambient environment will
cause residual water remaining inside the Unit to freeze resulting in damage to internal
components.
FIGURE 1. UNIVERSAL C-750 DISPENSER (FOUR-FLAVOR UNIT)