Filter
Top Products
Custom Panel Instructions
Items you will need:
- Custom Panel Door Front (max weight: 16 lbs)
o Panel MUST be ¾ inch thick.
- Tape Measure
- Electric Drill
- Torx (T-20) Head Screwdriver
- 1/8” Drill Bit
- 5/32” Drill Bit
- Masking Tape
- Safety Glasses
- Original Installation Instructions
Additional items required if using handle provided with dishwasher:
- ¼” – 20 bolt, 2 ½” long
- ¼” Drill Bit
ALL ELECTRICAL WIRING, GROUNDING AND PLUMBING SHOULD BE DONE IN
ACCORDANCE WITH NATIONAL AND LOCAL CODES BY QUALIFIED INDIVIDUALS
CHECK LOCAL PLUMBING CODES
FOR APPROVED PLUMBING
PROCEDURES AND ACCESSORIES.
This appliance must be connected to a
grounded metal, permanent wiring system;
or an equipment-grounded conductor must
be run with the circuit conductors and con-
nected to the equipment-grounding terminal
or lead on the appliance.
This dishwasher is designed for operation on
an individual 120 VAC, 60 Hz grounded
electrical circuit. Use required fuse (15 amp)
or comparable circuit breaker. Two wire
with ground service to the dishwasher is
recommended for connection at the
terminal box and for grounding.
Part No. 6 918803 A
'LVFRQQHFWHOHFWULFDOSRZH U WR
GLVKZDVKHUEHIRUH\RXVWDUW
)DLOXUHWRIROORZWKLVZDUQLQJFRXOG
5HVXOWLQGHDWKRU V HU LRXVLQMXU\