Menu

Page 9 of Jenn-Air JDB-5 Dishwasher User Manual

of 60
8
Adjustable Racks (select models)
The Adjustable Upper Rack (select models) and
Adjustable Middle Rack can be raised or lowered to
accommodate taller plates, platters, pans, etc. in the
upper, middle or lower racks. Full size dinner plates
can be loaded in the upper rack if it is in the lower
position. Always unload racks before adjusting.
To lower the rack:
1. Pull the rack fully out.
2. Place thumbs
on each lever
on the adjuster
while holding
rack with
hands.
3. Press down on
the levers with
thumbs and push rack down. T
he rack will come
to a stop when it is in position.
To raise the r
ack:
1. Pull the rack fully out.
2. Place hands on both sides and lift up until rack
comes to a stop and latches in place.
Notes
T
he dishw
asher will not
operate correctly if the
rack wash arm
connection is not aligned
with one of the water
inlet holes on back wall
of the dishw
asher
.
The left and right side adjusters on the racks
must both be fully in the upward or downward
position for proper connection.
Removing the Upper
and Middle Racks
The racks can be removed when tall or oversized items
need to be loaded into the middle or lower rack.
Unload the rack before removing it from the dishwasher.
To remove rack with push tab rack stops (select
models):
1. Roll the rack
1
3 to
1
2 of the way out.
2. To remove each plastic push tab rack stop from
the end of each track, push inward (toward the
rack) on the ridged area of the rack stop. The rack
stop will snap open and can be easily removed by
pulling straight
out. Take care to
support the track
while removing
rack stops.
3. Roll the rack all
the way out of
the track and
remove from the
dishwasher.
To replace:
Reverse the above procedure to replace the rack into
the dishwasher.
To remove rack with tab-lock rack stops
(select models)
1. Roll the rack 1/3 to 1/2 of the way out.
2. Locate the rack stops at the end of each track.
Squeeze the tab in the middle of the rack stop and
pull the rack stop straight out. Take care to support
the rack while removing the rack stops.
3.
Roll the rack all the
way out of the
track and remove
from the
dishwasher.
To replace:
1. Replace the
dishwasher rack by
guiding the wheels into the tracks.
2. Push each rack stop squarely into the end of the
track until the c
atch pops into the small hole on the
side of the track.
Adjusters
Push Tab
Rack Stop
LOADING
Tab Lock
Rack Stop
Tab Lock
prev next

Additional Jenn-Air JDB-5 Dishwasher Literature



Jenn-Air JDB-5 Dishwasher Discussions


Need help with this product?


Related Jenn-Air Products







TRUSTe Seal


  • Facebook
  • Twitter
  • ManualsOnline Blog
  • ManualsOnline Google Plus