Filter
Top Products
Minimum horizontal
clearance between the
edge of the appliance
and combustible
construction extending
from the cooking
surface to 18" above
the cooking surface is
2" (see solid areas)
Overall Dimensions
Cut-Out Dimensions
Top View (not to scale)
Cut-Out width:
Cut-Out depth:
Overall depth:
Overall width:
Countertop View
(not to scale)
Side View (not to scale)
Cooktop supplied with 1/2" NPT female inlet on regulator (shipped loose)
Top view of cutout
(not to scale)
Gas inlet location
C
L
12 7/16"
1 13/16"
Cabinet Requirements
Wall View
(not to scale)
Distance from top of counter to bottom of unit:
Min. spacing from cooktop edge to nearest
vertical combustible wall to the RIGHT:
Min. spacing from cooktop edge to nearest
vertical combustible wall to the LEFT:
Minimum spacing to front edge of counter:
Min. spacing from cooktop edge to nearest
vertical combustible wall to the REAR:
Minimum distance between cooktop
and cabinet directly above:
Minimum distance between countertop
and adjacent cabinet above:
Minimum width of cabinet directly above:
Maximum depth of cabinets directly
above and adjacent:
18"
13"
30"
30" min
2"
1 1/2"
8"
8"
20 5/8"
28 3/4"
3 13/16"
21 3/4"
30"
18"
30"
30" min
20 5/8"
28 3/4"
3 13/16"
21 3/4"
30"
• Distance from top of counter to bottom of gas stub is
3 7/16".
• Distance from top of counter including manifold
entrance is 7 13/16".
• Electrical requirements : 110/120 volt AC, 60hz. Must
be grounded. 15amp circuit required. Locate outlet
below the cooktop a minimum of 5" below the
countertop if not installing over an under counter oven.
Locate outlet below the oven or in an adjacent cabinet
when installing over an adjacent under counter oven.
• Minimum clearance from top of counter to combustible
material below is 4 7/16"
• Countertop must be supported within 3" of cutout.
• Unit may be installed over a Jenn-Air under counter
oven.
See page 2 for additional information
www.dexpress.com DIMENSION EXPRESS Fax on Demand (775) 833-3600
• Dimensions (Actual Size) •
• NEVER reuse Data Sheets. Data Sheets are subject to change without • Call Dimension Express if you have any questions at (775) 833-3633 •
notice. Dimension Express is a FREE service bureau and is updated daily, • Always refer to a current Code at a Glance or manufacturer directory •
it makes far more sense to spend the time necessary to request new Data • Data Sheet codes change on the first of odd numbered months at 12:01am •
Sheets for each project, as opposed to the problems, time, costs, and risks
associated with reusing old Data Sheets.
30" Gas Cooktops:
JGC8430BDS, JGC8430BDB, JGC8430BDQ and
JGC8430BDW
• Product Model Number (s): •
Subject to change without notice. This system is designed to
be updated daily if necessary. Dimension Express is not
responsible for use of superseded, voided, or outdated data
sheets. Because of the difficulty or impracticability of deter-
mining actual damages, liability of Dimension Express shall
not exceed $50.00.
Copyright © Dimension Express, 2004.
This Data Sheet Includes Information On
BN182.34 • A321B149 • • 041201 • 7461 • 64521
• Additional Information •
321
Jenn-Air