Kenmore 625.344800 Water Dispenser User Manual


 
MAKING PURIFIED WATER
1. Set the Purifier on your countertop or table. 6. Plug the power cord into any 120 volt outlet.
2. Unplug the kettle from the base (Figure 1). Twist
the cover counter-clockwise to remove, and set
aside.
3. Rinse and fill the kettle with tap water up to the
max. fill line.
NOTE: You can purify less than the full amount. Use
this chart as a guide. DO NOT fill the kettle over the
max. fill line because the carafe will overflow.
WHEN YOU FILL WITH THE CYCLE TAKES
TAP WATER TO... ABOUT...
Model 344800 (3 qt.) 5 hours
7. Press the reset or start button. The red indicator
light will illuminate.
When the cycle is over the Purifier turns offautomatical-
ly. AFTER THE FAN MOTOR GOES OFF, WAIT AT
LEAST 30 MINUTES BEFORE REMOVING THE
COVER...
WARNING: NEVER REMOVE THE COVER WHILE
THE FAN MOTOR IS RUNNING, OR FOR 30 MIN-
UTES AFTER IT STOPS. YOU COULD GET SE-
VERE BURNS FROM THE BOILING WATER OR
STEAM.
8. To pour water from carafe, open spout by pulling
on center strip in direction of the arrow indicator
near thumb position.
4.
Replace the cover on the kettle. Twist cover 9.
clockwise to lock. Plug the kettle into the base
unit. Carry carefully and keep level to prevent
splashing. 10.
Store the carafe filled with product water in the re*
frigerator until you need it.
5. Set the carafe into place on base unit.
CARE AND CLEANING OF YOUR WATER PURIFIER
After the Purifier has cooled (wait for 30 minutes
after the fan motor stops running) remove the
kettle to clean.
KETTLE CLEANING EXTERIOR SURFACES
After each use, rinse the inside with lukewarm tap water
and remove any residue. Clean by wiping out the inside
of the kettle with a damp cloth and rinse. If a deposit
starts to form at the bottom, use Kenmore Water Purifier
cleaner (see page 7). Residue build up on the bottom
of the kettle will prevent the system from purifying
a complete batch of water. Remove the kettle from
base unit. Fill kettle at the sink with hot water and follow
the instructions on the cleaner bottle. Rub with a soft
scouring pad and rinse thoroughly.
CAUTION: DO NOT IMMERSE THE PURIFIER OR
KETTLE IN WATER.
CARAFE
Clean with mild dish detergent and soft cloth. Rinse
thoroughly with water.
To keep your Purifier looking new, you should periodi-
cally clean the exterior plastic surfaces with a soft,
damp cloth. DO NOT use any caustic cleaning solu-
tions, scouring pads or powder because they will
damage the plastic finish.
NOTICE I
THERE ARE NO USER SERVICEABLE PARTS
INSIDE THE UNIT.
CHANGING THE OPTIONAL CARBON FILTER
PART NUMBER 32-34484 (not included)
NOTE: The purifier can use a carbon filter in the carafe
cover to remove traces of odors before the purified wa-
ter is collected inthe carafe (filter not included with puri-
fier). The filters last about 2-3 months. A return of un-
wanted odor means the filter should be replaced. Order
replacement carbon filters from Sears (see page 6).
continued, page 5