Kenmore 790.99013 Cooktop User Manual


 
Setting Surface Controls
FEATURE OVERVIEW
Operating the Bridge Radiant Element Surface
Control (cont'd)
To Operate the Bridge Surface Element:
1. Place correctly sized cookware on the Bridge surface
element.
2.
Push in and turn the control knob counterclockwise (See
Figs. 1 and 2) to heat the portion of the Bridge element for
normal shaped cookware or clockwise (See Figs. 3 and 4)
for larger or rectangular shaped cookware.
.
Figure 1 Figure 3
Figure 2 Figure 4
Figure 5
Use the ESEC digital display window for the desired
setting. Turn the knob to adjust the setting if needed. Start
most cooking operations on a higher setting and then turn
to a lower setting to finish cooking. Each surface element
provides a constant amount of heat at each setting. A
glowing red surface heating area extending beyond the
bottom edge of the cookware indicates the cookware is too
small. Please note that not all cookware will fit the Bridge
element correctly.
When cooking has completed, turn the surface control
knob to OFF before removing the cookware. The HE
message wilt appear in the display after turning the control
knob to OFF if the cooktop is still hot and will remain on
until the radiant heating surface area has cooled
sufficiently.
The BRIDGE element may also be used in combination with
the left rear single element. Because these elements have 2
different controls, one element can be used to cook while the
other element may be used to keep food warm (See Fig. 5).
Note: See page 8, Figure 5 for recommended control settings.
Radiant surface elements may appear to have cooled after they have been
turned off. The glass surface may still be hot and burns may occur if the glass surface is
touched before it has cooled sufficiently.
Surface Cooking
FEATURE OVERVIEW
Usingthe Proper Cookware
Cookware should have flat bottoms
that make good contact with the entire
surface heating element. Check for
flatness by rotating a ruler across the
bottom of the cookware (See Fig. 6).Be
sure to follow the recommendations for
using cookware as shown in Fig. 7.
Figure 6
Note: The size and type of cookware used will influence the
setting needed for best cooking results.
Deep fat frying - Use a thermometer and adjust the surface
control knob accordingly. If the fat is too cool, the food will absorb
the fat and be greasy. If the fat is too hot, the food will brown so
quickly that the center will be undercooked. Do not attempt to
deep fat fry too much food at once as the food will neither brown
nor cook properly.
*CORRECT INCORRECT
u
t t
Flat bottomand straight
sides.
Tight fitting lids.
Weight ofhandle does not
tiltpen. Pan iswell
balanced.
Pan sizes match the
amount offood to be
prepared and the size of
the surfaceelement.
Made ofe materialthat
conductsheat well.
Easy to clean.
Alwaysmatch potdiameter
toelement surface
diameter.
Curvedandwarpedpan
bottoms.
U
Panoverhangselementby
morethanone-halfinch.
m
Panissmallerthan
element.
Heavy handle tilts pan.
Figure 7
11