Filter
Top Products
Application Guidelines/Water Supply Parameters
Service Flow 0.5 gpm (1.9 Ipm)
Water Supply Potable Water
Water Pressure 20 -120 psi (138 - 827 kPa)
Water Temperature 33°F - 100°F (0.6°C - 38°C)
It is essential that the manufacturer's recommended
installation, maintenance and filter replacement
requirements be carried out for the product to perform
as advertised.
Note: While the testing was performed under standard
laboratory conditions, actual performance may vary.
Replacement Filter: ADQ36006102
For estimated costs of replacement elements please
call 1-800-469-4663 or visit our website at
www.sears.com/partsdirect
3M is a trademark of 3M Company.
NSF is a trademark of NSF International.
© 2009 3M Company. All rights reserved.
To reduce the risk associated with ingestion
of contaminants: Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection before
and after the system. Systems certified for cyst
reduction may be used on disinfected water that
may contain filterable cysts. EPA Establishment
Number 10350-MN-005
To reduce the risk associated with property
damage due to water leakage:
• Read and follow Use Instructions before
installation and use of this system.
• Installation and use MUST comply with all state
and local plumbing codes.
• Do not install if water pressure exceeds 120 psi
(827 kPa). Contact a plumbing professional if you
are uncertain how to check your water pressure.
• Do not install where water hammer conditions
may occur. If water hammer conditions exist you
must install a water hammer arrester. Contact a
plumbing professional if you uncertain how to
check for this condition.
• Do not install on hot water supply lines.
The maximum operating water temperature of this
filter system is 100°F (38°C).
• Protect filter from freezing. Drain filter when
temperatures drop below 40°F (4.4°C).
• The disposable filter must be replaced every
6 months or more often depending on useage.
30