Kenwood JK940 Hot Beverage Maker User Manual


 
safety
Avoid contact with steam coming
out of the spout area when pouring
and out of the lid when refilling.
Keep small children away from the
kettle and never let the cord hang
down over the worktop edge - a
child could grab it and pull the kettle
down.
If you do not need so much cord,
shorten it by wrapping any excess
cord around the bracket on the
underside of the powerbase .
Always unplug your kettle when not
in use.
Never overfill - boiling water may
splash out.
Never put the kettle, powerbase,
cord or plug in liquid.
Do not use if there is any damage
to the kettle, powerbase, cord or
plug. Get it checked or repaired: see
‘service’.
This kettle is not intended for use by
young children or infirm persons
without supervision.
Young children should be supervised
to ensure they do not play with the
appliance.
Caution: Do not operate the kettle
on an inclined surface.
Only use the powerbase supplied
and keep it clean and dry.
Make sure the lid is secure before
switching the kettle on.
Warning: Do not open the lid while
the water is boiling.
Take care when opening the lid -
droplets of hot water may be
ejected.
Make sure the kettle is switched off
before lifting or pouring.
Remove the kettle from the base
before filling or pouring.
Never put the kettle near or on
cooker hot plates or gas burners.
This kettle is for boiling water only.
This kettle is for domestic use only.
Failure to observe these cautions
may result in damage to the kettle.
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your kettle.
This kettle complies with European
Economic Community Directive
89/336/EEC.
before using for the first time
Remove all packaging and any
labels.
Fill to ‘MAX’, boil, then pour the
water away. Repeat 2 to 3 times.
key
flip top lid
lid release button
on/off switch
360° powerbase
neon light
water level windows
scale filter
cord storage
to use your jug kettle
1 Fill it through the spout or lid. To
open the lid, press the lid release
button. The water level must be
between ‘MAX’ and 200mls (1 cup).
Be economical: do not boil more
water than you need.
To improve the quality of your drinks
always use fresh water.
Empty the kettle after each use.
2 Check the lid is closed.
3 Plug in and switch on. The neon will
come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
If you experience problems
with your kettle switching on
and off during use or
switching off before boiling,
check that the flat element is
free from scale - see
“descaling”. If descaling does
not solve the problem contact
Kenwood Customer Care.
2
English